Unsmoke Degrease-All E for Electronics Clearance

UNSMOKE DEGREASE-ALL E - 1 GALLON 

Degrease-All E is a highly concentrated cleaner and degreaser for electronic equipment. Highly effective at removing smoke damage and fire related deposits. Rinses clean and leaves surfaces residue-free

• Form: Liquid concentrate
• RTU pH: 11.5
• Storage and transport: Protect from freezing
• Flash point:
  • <200°F
  • 93.3°C

• Specially formulated to clean, neutralize and degrease electronic components exposed to smoke and soot
• Fully water soluble rinses off clean and leaves no residue
• Use in spray systems or with ultrasonic cleaning equipment

PROCEDURE Pre-conditioning: Prepare a ready-to-use (RTU) solution by diluting 12 ounces of concentrate with enough hot tap water  (94 mL/L) to make one gallon. Place in hand trigger sprayer. Lightly spray smoke damaged surfaces, agitate with soft brush. Increase the concentration to as much as 32 ounces per gallon (250 mL/L) depending on soiling conditions. 
 Brush on application: Prepare a ready-to-use solution of Degrease-All E by diluting 12 ounces of concentrate with enough hot tap water (94 mL/L) to make one gallon and place in wide mouth container. (Increase the concentration to as much as 32 ounces per gallon (250 mL/L) depending on soiling conditions.) Use a soft brush to apply or agitate the RTU solution on target surfaces. Rinse with deionized or distilled water until no soap bubbles are visible. Remove moisture by blowing with compressed air and oven drying.  
 Ultra-sonic cleaning: Add 2 ounces of concentrate per gallon (16 mL/L) of water in cleaning tank. Rinse with purified water after cleaning. 
 Siphon application: Prepare a ready-to-use solution by diluting 12 ounces of concentrate with enough hot tap water  (94 mL/L) to make one gallon. (Increase the concentration to as much as 32 ounces per gallon (250 mL/L) depending on soiling conditions.) Place in detergent reservoir. Spray soiled surfaces until clean and then rinse with purified water until no soap bubbles are visible. Remove moisture by blowing with compressed air and oven drying.